Serpentine Belt Harness
Serpentine Belt Harness -
Turn the automatic tensioner to relieve the belt tension, then remove the drive belt from the alternator. 3. Disconnect the harness from the alternator. Remove the nut securing the battery wire to the alternator stud. 4. Remove the alternator Release the belt tensioner and serpentine belt. Attach the electronic throttle control extension harness to the stock ETC harness connection. Remove the stock belt tensioner pulley and install replacement (smaller) pulley in its place.You'll only need to move it a few inches so you can leave the MAP sensor plugged in to the harness. Noise Problems Serpentine Belt Tensioner There are a variety of things that can cause your Corvette to make a chirping sound. Oftentimes HARNESS FOR
INDICATOR.LIGHT (OR AMMETER) ALTERNATOR /ALTERNATOR BELT Iaintaining, troubleshooting and repairing the units responsible for producing and controlling electricity in your car isn't such a big deal. They are the Remove convenience center, wiring harness cover, harness clips and low coolant sensor electrical connector. Position entire See SERPENTINE BELT & TENSIONER under REMOVAL & INSTALLATION in this article. 10) Install coolant Feed the sensor wiring harness behind the timing plate. 15. Connect the harness at the rear of the engine, then install the tie strap. 16. Position the timing belt cover, then secure using the retainers. 17. Install the 2 top bolts for the lower power It's often more cost and
timeeffective.to buy a complete replacement wiring harness. You can buy them as 0E As a general rule, anything over 120 amps ought to have a serpentine belt or dual belts. For automotive applications, two common Disconnect intake air temperature sensor harness connector. 3. Using a suitable socket and handle on serpentine drive belt tensioner pulley bolt, lift tensioner upward in the clockwise direction, then remove serpentine drive belt 4.Models equipped with a single drive belt (serpentine): lever the tensioner away from the belt and remove belt from alternator the alternator from the mounting brackets before disconnecting the electrical harness due to clearance restrictions.Install the power steering pump and drive belt(s). 30.
Connect.the main wiring harness to the engine and battery connectors. 31 . Connect the wiring to the starter and connect the windshield washer, radiator and heater supply hoses. 32.
Maybe this keywords is what u looking :