Fuel Pump Pulley
Fuel Pump Pulley -
In 1982 the mechanical, enginemounted fuel pump is replaced with an electric unit mounted inside the fuel tank. On 1978 and 1979 cars equipped with an Air Injection Reactor pump, the water pump pulley that drives the pump has the Heater fuel filter clogged— Ignition cable defective Magneto pulley slipping— . Fuel supply low (electric motor power unit installed). Tube assemblies clogged or frozen. Fuel control valve connection loose. Fuel pump pulley slipping.Underdrive pulleys typically gain the same amount throughout the rpm band because they are not making more power, rather they are freeing up power the engine already makes. RACETRONIX FUEL PUMP SETUP Reinstall the fuel level Fuel Pump As with a bypass valve, making sure
you.have the right fuel pump is critical. under greater rpm/boost, which allows the blower belt to fly off, causing the supercharger pulley to freewheel and damage the impeller mechanism.Fan Drive and Water Pump Pulley NOTE It may be necessary to apply compressed air to fan drive fitting. Oil Filter, Adapter, and Oil Pressure Sending I nit R Fuel Injection Lines u. Oil Pan h. Fuel Supply and Return Lines v. Oil Pump i.21 crankshaft hub positioning Pig. 24 infection pump pulley removal 13. Rotate crankshaft two complete revolutions in normal direction of rotation to seat timing belt, then rotate an additional 90° beyond TDC to settle injection pump, Fig. 21.Disconnect the fuel line at the fuel pump and remove the pump. Lower the vehicle.
6..Remove the bypass hose. Remove the power steering pump drive belt if equipped. Remove the water pump pulley and disconnect the heater hose at the 41 10.8 engine INJECTION PUMP REPLACE lMARK 1 . Remove timing belt See 'Timing Belt, Replace." 2. To prevent rotation of injection pump pulley during disassembly, thread a 8 mm 1 .25 pitch bolt through the pulley into the housing, Loosen tension pulley and plate bolts. Remove timing belt. Remove nut attaching injection pump pulley. Using gear puller, remove injection pump pulley. Remove lock bolt. 5) Disconnect wiring from fuel cut solenoid valve switch and 0103 FLYWHEEL ASSEMBLY Flywheel 0.5 (Includes removal and replacement of starting pulley and screen.) ENGINE
STARTING.SYSTEM Guard 0.2 Pulley, starting 0.3 0108 MANIFOLDS Manifolds, intake 0.3 03 FUEL SYSTEM 0301
Maybe this keywords is what u looking :